Our Advantage
Particle control design of scheduling automation system
1. The contact guide part between the incoming logistics line and the battery is a rubber-coated bearing
2. The parts that are in contact with the battery cell, such as grippers, are made of non-metallic materials such as POM or rubber
3. All relative sliding parts are connected by guide rail or cylinder, no sliding friction and all designed with dust covers
4. Flexible gripper spring with non-metallic spacer sleeve.
Drying oven Particle control design
1. Add a double filtration device at the inlet of nitrogen/dry compressed gas in each furnace, and the filtration accuracy of the first layer is ≤ 15μm, = the filtration accuracy of the second layer is ≤5um.
2. The vacuum pump pipeline is equipped with dust filtration to prevent dust from entering the vacuum pump, and cooling water filtration to prevent the cooling pipeline of the vacuum pump from blocking.
3. The fixture positioning adopts non-metallic PPS positioning sleeve to avoid metal friction.
Cooling system Particle control design
1. The cold air adopts the air circulation in the dry room
2. Configure a filter in the air duct
